Manual

20639-01 Rev 03

The following figure shows an example of the second type of

parameter editing. In this case the whole parameter is highlighted and

the up and down arrow keys will cycle between the available settings.

When editing a parameter the ‘ENTER’ key will accept and save the

current value. Alternatively the ‘BACK’ key will revert the current

parameter to the value before editing was begun. The ‘EXIT’ key will

also revert to the previous value (similar to the ‘BACK’ key) and will

exit Menu mode. While in Menu mode the screen will return to

operational mode and resume operation after 5 minutes of inactivity.

OUTOUT CONFIG

• 4-20mA Ch1

POWER SEL.

INTERNAL

Figure 57 Editing Whole Parameter

Table 13 on the following pages gives details on the full menu tree.