Manual

20639-01 Rev 03

9.5.1.2 Operating Transmitter Display

In operating mode the display screen is split into three distinct

portions. The majority of the screen is devoted to a 2-line

measurement display as illustrated below. The bottom portion of the

screen will display status and configuration information.

Figure 52 Operating Transmitter Display

9.5.1.2.1 Line 1 / Line 2

Either line may be configured to display any of the values listed below.

Value Units

Gas Volume Fraction Percent (%)s

Speed Of Sound Feet per Second (fps) or Meters per Second (mps)

Blank Line is blank

Table 7 Line 1 and Line 2 Values

9.5.1.2.2 Status Line

The code for information in the status line shown in Figure 52 are

defined as follows:

ID Characters Description Values

S 20 Status Messages See Status Messages Table below

Q 11 Quality Field See Quality Field Message Table below

M 4 Mode See Operating Mode Message Table below

C 1 Communications E – Ethernet or S – Serial

H 1 Hart Activity H – Hart Message received or [blank] – No Activity

W 1 Write Protect W – Write Protected or

[blank] – Not Write Protected

E 1 Event Log Updated

! – Event Log Updated or [blank] – No change to

Event Log since last check

A 1 Activity |/-\ (Cycle changes indicate activity)

Table 8 Status Line Code

2.016 %

351.7 ft/s

SSSSSSSSSSSSSSSSSSSS QQQQQQQQQQQ MMMM CHWEA

Gas Volume

Fraction

Speed Of

Sound

Line 1

Line 2

Status Line