Instruction Manual
WARNING
Discharge each sensor per user manual instructions just prior to
connecting sensors to preamp. Failure to do so may result in
damage to preamp!!
Starting with sensor #1, discharge that sensor by attaching it to the
sensor shorting plug. Insert the sensor connector into the mating
connector (connector #1) mounted on the bottom of the preamplifier
module. Repeat for the remaining 9 wires. Note: It may be easier to
connect the sensors by first removing the connector block and then re-
installing the block after all connections have been made.
Turn the pre-amplifier over.
Re-install the four pre-amplifier mounting screws.
Connect the wire interconnect wire connector to the pre-amplifier.
Interconnect
wire connector
Figure 17 Wired and Mounted Pre-amplifier
Ensure the grounding wire is attached to the pre-amplifier cover
Install the preamplifier cover and install the four cover screws.
21020-01 Rev 01 Page 2-15