User's Manual

E272 - 2.4GHz Cordless
INSTALLING THE E272 1
INSTALLING THE E272
CHECK THE CONTENTS
Check to see that the following items are enclosed:
■ Telephone Base and Handset
■ Long Line Cord
■ Short Line Cord for Wall Mounting
■ Desktop/Wall Mount Wedge
■ AC Adapter
■ Battery Pack
■ Spare Battery Pack (optional)
■ Belt Clip
■ User Manual
■ Quick Start Card
CHOOSE A LOCATION FOR THE BASE UNIT
The base should be away from all other electronic
equipment such as a personal computer, microwave,
stereo, or television. It is also a good idea to place the unit
away from noisy areas, or from heat sources such as a
radiator or direct sunlight.
PLUG IN THE ADAPTER
a. Plug the AC adapter tip into the DC 9V jack on
the base and the other end into an electrical
outlet. Be sure that the tip is securely plugged
into the jack. Without AC power your phone will
not operate.
CAUTION
You must use a Class 2 power adapter that supplies
9 Volts DC and delivers at least 600mA. Its center
tip must be set to positive and its plug must fit the
phone’s DC 9V jack. The supplied adapter meets
these specifications. Using an adapter that does not
meet these specifications could damage the phone
or the adapter.
b. Thread the cord through the clip on the
housing to prevent the cord from pulling
loose. Be sure that the wall outlet is not
controlled by a light switch.
120V WALL
OUTLET
TELEPHONE
WALL OUTLET
AC ADAPTER
DC9V
JACK
BASE
TEL Line
JACK
LONG LINE
CORD