User's Manual

E272 - 2.4GHz Cordless
4 INSTALLING THE E272
ATTACHING THE MOUNTING
W
EDGE
Install the wedge by aligning it over
the holes and pressing in the
opposite direction of arrow until it
snaps in place.
INSTALL THE TELEPHONE LINE
C
ORD
DESKTOP OR TABLETOP
a. Plug the long line cord into the phone jack
marked TEL LINE.
b. Plug the other end of the line cord into the
wall jack.
WALL MOUNT
a. Plug the short line cord into the phone jack
marked TEL LINE.
b. Thread the phone cord through the open
channel in the base.
c. Plug the other end of the phone cord into the
wall phone jack.
d. Use the gap on the underside of the base to
gather any excess cord.
e. Hang the base over the installation hooks
(wall plate not supplied).
ATTACH THE BELT CLIP
The belt clip is used to hang the handset from your belt.
Place the belt clip on the back of the handset. Align the tabs
on the belt clip with the slots on the handset. Press the belt
clip to the handset to snap the tabs into the slots. Make sure
both tabs are securely snapped into the handset slots.
ATTACH HEADSET (OPTIONAL)
A headset with a standard 2.5 mm plug (min 150Ω) may be
used in the headset jack on the side of the handset. Keep
the headset jack cap in place when the headset is not in use.