User's Manual

D933 - 900MHz Cordless
vi SAFETY INSTRUCTIONS & WARRANTY
FCC PART 68 INFORMATION
This telephone is hearing aid compatible.
This equipment complies with Part 68 of the FCC rules. The FCC
Part 68 label is located on the bottom of the product. This label
contains the product’s FCC Registration Number and Ringer
Equivalence Number (REN). You must give this information to
your telephone company if they request it from you.
Only use standard modular telephone jacks to connect to the
telephone network. The appropriate outlet or jack is a USOC
RJ11C or RJ11W, which complies with FCC Part 68 Rules.
The REN is useful when trying to determine the maximum
number of devices you can connect to your telephone line and still
have those devices ring when called. In most, but not all areas,
the sum of the RENs of all devices connected to one line should
not exceed five (5.0). To be certain of the number of devices you
can connect to your line, as determined by the REN, contact your
local telephone company to determine the maximum REN for
your calling area.
If this device causes harm to the telephone network, the
telephone company will give you advance notice if temporary
discontinuance of service is required. But if advance notice isn’t
practical, the telephone company will notify you as soon as
possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities,
equipment, operation, or procedures that could affect the proper
functioning of your equipment. If they do, you will receive
advanced notice in order for you to make necessary changes to
maintain uninterrupted service.
This equipment may not be used on coin service provided by the
telephone company. Connection to party lines is subject to state
tariffs.
Repairs to this equipment can only be made by the manufacturer
and its authorized agents. If it appears that this device is causing
harm to the telephone network, the telephone company might
request that the device be unplugged until the problem is fixed.
DO NOT DISASSEMBLE THIS EQUIPMENT.
"IMPORTANT NOTE; To comply with FCC RF exposure
compliance requirements, use only the antenna that is
installed on the telephone. Avoid direct contact to the
antenna while talking. Base set should be positioned to
provide a separation distance of at least 20 cm away
from all persons."