User's Manual

3. Plug the five inch line cord into the phone jack marked TEL LINE.

4. Thread the line cord through the open channel in the base.

5. Plug the other end of the line cord into the wall jack.

6. Use the gap on the underside of the base to gather any excess cord.

7. Hang the base over the installation hooks.

4. INSERT THE BATTERY INTO THE HANDSET

Use this procedure to install or to replace a battery.

Be sure you follow the battery specifications and

safety instructions outlined in your safety

instruction booklet.

! CAUTION

Use only Cidco brand nickel cadmium (Ni-

Cad) batteries in this phone (Part No.

102794-01).

1. Press down on the battery cover and slide the

cover down to expose the battery

compartment.

2. Locate the battery terminals inside of the

battery compartment and the corresponding

terminals on the battery pack. Align the pack’s

terminals with the terminals in the battery

well.

3. Replace the battery door.

5. CHARGE THE HANDSET

Before you use the phone for the first time:

1. Ensure the handset is turned off.

2. Place the handset in the cradle and charge the battery for at

least 12 hrs with the Off-On switch set to OFF. The charge light

on the base comes on to tell you that the handset is charging.

CL940SwbRevAFinal.book Page 6 Thursday, August 19, 1999 5:45 PM