User's Manual

SETTING UP YOUR PHONE

It only takes a few steps to set up your phone. Now that you’ve checked the

contents of the carton, you are ready to put the phone together.

1. CHOOSE A CENTRAL LOCATION FOR THE BASE UNIT

The base should be away from all other electronic equipment such as a personal

computer, microwave, stereo, or television. It is also a good idea to place the unit

away from noisy areas, or from heat sources such as a radiator or direct sunlight.

2. PLUG IN THE ADAPTER

1. Plug the adapter tip into the round jack

on the base and the other end into an

electrical outlet. Without AC power your

phone cannot operate.

2. Thread the cord through the clip on the

housing to prevent the cord from pulling

loose.

1. INSTALL THE LINE CORD

You can set your CL940 telephone on a tabletop or you can mount the phone on a

wall.

To use on a tabletop or desk:

1. Take the long telephone line cord that comes with the phone and

plug one end into the jack labeled TEL LINE.

2. Take the remaining end and plug it into the wall jack.

To mount on a wall:

1. Remove the

mounting wedge

from the bottom of

the base by

placing your

thumb at the top

of the arrow on the

mounting wedge

and pressing down

in the direction of the arrow.

2. Turn the wedge around and place it over the lower portion of the

base. Reinstall the wedge by placing your thumb over the arrow

and by pressing downwards and backwards until it snaps into place.

CL940SwbRevAFinal.book Page 5 Thursday, August 19, 1999 5:45 PM