User's Manual

CL906 - 900MHz Cordless
8 INSTALLING THE CL906
b. Thread the cord through the hook on the
housing to prevent the cord from pulling
loose. Be sure that the wall outlet is not
controlled by a light switch.
Step 3: Install Handset Battery
CAUTION
Risk of explosion if battery is replaced by an
incorrect type. Use only 3.6V 800mAh Nickel
Cadmium (NiCad) cordless telephone replacement
battery pack.
Do not attempt to open the sealed battery pack. All used
Ni-Cad batteries must be recycled or disposed of properly
in accordance with all applicable laws.
If this is the first time you are installing the
battery, the battery cover is not on the
handset. It is located in your accessory
packet. Skip step a.
a. Remove the battery cover by sliding it
out.
b. Locate the battery connector inside the
battery well. If you are replacing a
dead battery, remove the old battery
by pulling firmly on the battery cords.
c. Insert the battery plug into the
connector. It is polarized and only
inserts in one direction.
d. Place the battery in the battery well.
Make sure that the battery cords are
on top of the battery. Do not lay the
battery on top of the battery cords,
otherwise the cords may become
pinched.
e. Replace the battery cover by sliding it
into place.
f. Place the handset on the base and let
the battery charge for a full 12 hours
before using the telephone.
!
DC 9V
CL906.book Page 8 Friday, January 18, 2002 2:25 PM