Operation Manual

|
7
Chapter 3 – settInGs & fIrst start
In this chapter you will learn how to install and set up the CM 9.3 A (+) before the first ride. Please note that
functions with this Symbol are only available with the (+) Version or with the optional accessories.
3.1 Mounting
3.1.1 Handlebar bracket
You can mount the handlebar bracket on the handlebar or on the stem. For mounting it on the stem, unscrew
the four screws as shown in picture 1, turn the lower part of the handlebar 90° degrees and secure it again
with the screws.
Peel off the adhesive protection and attach the rubber pad to the bottom side of the handlebar bracket.
Run the cable ties through the eyelets and position the handlebar bracket on the handlebar or on the stem.
Fix the mount with the cable ties. The ends of the cable ties can be cut off with a clipper or scissors.
3.1.2 Speed sensor
Attach the transmitter to the fork or the left chain stay. Pull the cable ties through the eyelets of the trans-
mitter, place it in the desired location and tighten the cable ties. The ends of the cable ties can be cut off with
a clipper or scissors.
3.1.3 Cadence kit
Mount the sensor as shown in picture 2 (do not tighten the cable ties, yet). Attach the cadence magnet as
described below and check the maximum distance of 3mm. Only after the cadence is initialized (Section
3.7.1), tighten the cable ties. The ends of the cable ties can be cut off with a clipper or scissors.
3.1.4 Spoke magnet
Attach the magnet to a spoke on the opposing of the transmitter.
Please note that the distance between the sensor and the magnet shall not be more than 3mm.
Please make sure to align the magnet on the markings on the sensor.
3.1.5 Trittfrequenz-Magnet
Attach the cadence magnet with a cable tie to the left crank arm, as described in picture 2. Please note that
the distance between the sensor and the magnet must not be more than 3mm.
Please make sure that the magnet is aligned with the marking on the sensor.
3.1.6 Heart rate belt
Attention: Every person who carries out sport should have a general medical checkup on his/her general
state of health Especially beginners, persons older than 35 years of age and anyone who has suffered from
illnesses or injuries in the past. It is recommended that a doctor is consulted in case of risk factors, such as
smoking, high blood pressure, high cholesterol values, diabetes, lack of exercise and excess weight.
Pacemaker wearers should consult their doctor before using any heart rate measurement
device!
Moisten the contacts on the harness and attach the transmitter belt. The chest strap should be worn centered
just below the nipples.
The heart rate can only be displayed if:
- The chest belt fits correctly
- The heart rate function is activated (Chapter. 3.7)
- The heart rate belt has been initialized with the CM 9.3 A (+)
1
2
4
5
7
6
3