Installation Manual

Installation Manual Page 47 of 49 MICRORAY

4.1.2.3 Read/Write Masking threshold

Carrying the function switch SW1 to position 6, it is possible to read and/or set masking.

Select Masking:

• Select a number from 00 to 02 on the appropriate switches SW2 (tens) and SW3

• Press the button S3, to confirm its acquisition and use

Read set Masking;

• Turn the SW2 switch until the red LED (D9) is on

• Turn the switch SW3 until the red LED (D8) is on

The number from 00 to 02 represented on the SW2 (tens) and SW3 (units), corresponds to

the masking threshold currently assigned to the ray.

Number

Masking Threshold

SW2

SW3

Low

Middle

High (default)

4.1.2.4 Walk-Test

Setting the function switch SW1 to position 4, it is possible to carry out the Walk-Test. The ray

will work with the set parameters and once the ray is interrupted, the buzzer present inside the

Rx circuits will be activated with a continuous sound.

4.1.2.5 Final Operation

Turn the function switch SW1 to position 0 and press the “S3” button to conclude all the ray

installation phases and stores the thresholds selected in the previous phases.

NB: If the barrier is powered off or reset, before having stored the parameters, all the settings

made will be lost.

5 MAINTENANCE & ASSISTANCE

Ray Replacement

MICRO-RAY-RTV13-KIM and MICRO-RAY-RRV13-KIM codes shall be used to replace ray 1

(Default) or ray 3, respectively on column A and B (see table with RAY REPLACEMENT CODES

at page 29).

To configure MICRO-RAY-RTV13-KIM and MICRO-RAY-RRV13-KIM to replace ray 3, you must

connect and turn on the ray, turn the functional switch SW1 to position 7, and using the SW2

(tens) and SW3 rotary switches (units), set the number of ray you want configure (03).

Press "S2" micro-switch on TX or "S3" push-button on RX and check the leds of the Fault (D6)

and Tampering (D5) lights up, confirming the acquisition of the new ray number set.

MICRO-RAY-RTO24-KIM, MICRO-RAY-RRO24-KIM, MICRO-RAY-RRO24-KIM and MICRO-

RAY-RTO24-KIM codes shall be used to replace ray 2 (Default) or ray 4, respectively on column

A and B(see table with RAY REPLACEMENT CODES at page 29).