User`s manual

System Check Screen

Highlight System Check in the Main menu and press the

button. The System Check setup

screen appears.

Figure 29 — System Check screen.

Highlight the box under the On/Off heading and press the

button. This toggles between On

and Off. When it is On, the DVR reports a fault condition if it does not detect any recording or if

there is an alarm during the designated time.

Highlight the box under the Interval heading and press the

button. A slide bar appears

allowing you to set the check interval from 1 Hour to 30 Days by using the Left and Right arrow

buttons.

The Status field displays the fault conditions. When it is Good, there was recording or an alarm

occurred during the designated time. When it is Bad, there was no recording or no alarm

occurred during the designated time.