User manual

User’s Manual
12
NOTE: First, select the mode button between and to set up the motion-detecting
zone. And then select the area to set or release using one of the three tools.
CAUTION: When using a modem for remote connection, the current connection of the
RAS Watch will be disconnected if you initiate the motion-detecting zone setup. After
setting up the motion detection, connect to the target site again.
υ System Log Button
Displays the system log information of a remote DVR. If the user sets the period of interest
and clicks the Find button, the system log entries within the period are displayed in the list. A
total of 100 results can be displayed in the list at a time, so click the
(Next) button to
display the next results.
• From: If this box is checked, search from the first remote system log. If you want to a
specific starting date/time, remove a check and then set the desired date/time
• To: If this box is checked, search until the last remote system log. If you want to a specific
ending date/time, remove a check and then set the desired date/time.
• Find: Displays remote system log entries within preset period.
•
(
First): Moves to the first page of the found log entries.
•
(
Previous): Moves to the previous page.
•
(
Next): Moves to the next page.
•
(
Last): Moves to the last page of the found log entries.
• Save: Saves the log information to the text file.
• Print: Prints the log information out.
• Close: Closes the Log dialog box.