User's Manual

1. Do not immerse the unit in water.
2. Do not leave disabled battery in the watch for a long time and be sure to replace it with new ones.
If battery fluid leaks out, it may damage movement components.
3. Avoid rough using or dropping the unit.
4. To clean the unit, use a dry soft cloth or a soft cloth moistened in a solution of water and a mild
neutral detergent. Never use solvents (such as benzene, spray cleanser).
5. Always read the users manual thoroughly before operating the unit.
FCC Remarks:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
SPECIFICATIONS
Our temperature measuring range: -20 °C to +60 °C
Recommended operating range: -20 °C to +50 °C
Temperature resolution: 0.1 °C / 1°F (above 0 °C)
1 °C / °F (below 0 °C)