User's Manual

Copyright © Chung Nam Electronics. All Rights Reserved.
5
Federal Communication Commissions Compliance
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
y Reorient or relocate the receiving antenna
y Increase the separation between the equipment and receiver
y Consult the dealer or an qualified radio/TV technician for assistance
FCC NOTICE: To comply with FCC part 15 rules in the United States, it is the
responsibility of the operator and module embedding manufacturer to ensure that only
certified systems are deployed in the United States. The use of the system in any other
combination (such as co-located antennas transmitting the same information) is
expressly forbidden.
Note:
Changes or modifications not expressly approved by the party responsible for
compliance could void the users authority to operate the equipment.
Radio Frequency Radiation Exposure Evaluation
Three different categories of transmitters are defined by the FCC in OET Bulletin 65.
These categories are fixed installation, mobile, and portable and are defined as
follows:
Fixed Installations: fixed location means that the device, including its
antenna, is physically secured at a permanent location and is not able to be
easily moved to another location. Additionally, distance to humans from the
antenna is maintained to at least 2 meters.