User's Manual

- 17 -
10. Barcode Test
This terminal features a built-in barcode test, which is accessed
from the [Tools] group.
In this application, there are two ways to trigger a barcode scan, via
either the hardware (image 1) or the software (image 2). Operation
is as follows:
1. Hardware trigger: with the object focus on “Barcode”, press the
“Scan” button to scan a barcode. This type of scan will stop for the
following reasons:
‧ Successful read of a barcode
‧ Scan key is released
‧ Scanning for several seconds without successful read
2. Software trigger: with the object focus on “Test”, press this object
or the “Click” button to scan a barcode. When using the software
trigger, the scan process cannot be interrupted; however, the scan
results will display the type of barcode read. This type of scan will
stop for the following reasons:
‧ Successful read of a barcode
‧ Scanning for several seconds without successful read
(
1
)
(
2
)