User's Manual

To enjoy a life of wireless video and audio, just connect the transmitter to any
A/V source you like and connect the receiver to a TV, monitor or speaker in
another location.
□ Transmitter
□ Receiver
For optimal performance, both the audio/video and remote control antennas
should be carefully oriented as described below. For maximum transmitting
range, try to minimize obstacles (e.g. your TV or other electronics, large
furniture) where between the transmitter and receiver.
Orients the 5.8GHz A/V Antennas
NOTE: Make sure the ON/OFF switch is in the
「OFF」
position before connection
3. Setup Guide
1.
Connect one end of the RCA cable (or
scart cable) to the audio and video jacks,
and connect the other end to a source
device via its “AV output”.
2. Connect t
he DC plug of the adapter to the
DC jack, and connect the power supply to
an outlet.
3.
Fix IR mouse next to or in front of IR
sensor of source device, or alternatively
have transmitter
facing directly toward the
source device.
4. Orient Transmitter/Receiver for optimal performance
The system delivers high-
quality audio and
video by using directional antennas, which must
be oriented in the best ways. The antennas are
designed to be able to vertically and
horizontally
pivot and rotate in almost any direction.
In most situations, the flat-pitted face of the antennas on both the tr
ansmitter
and receiver should be facing one another and perpendicular (at a right angle)
to an imaginary line drawn between the two units. Three examples are shown
as Fig-1, Fig-2 and Fig-
3. Since all homes are different, for optimal reception,
additional
slight pivots or rotations may be necessary. If the transmitter and
receiver are less than 10 feet apart, suggest that the antennas are lying on their
casings since the distance is so short. 1
Connect one end of the RCA cable (or
scart cable) to the audio and video jacks
and connect the other end to a TV (or
monitor, speakers) via its “AV input”.
2 Connect the
DC plug of the adapter to
the DC jack, and connect the
power
supply to an outlet.
4 5
3. Keep the IR window oriented toward front when using your source device
remote
controller.