User Manual

Manual
waterdocs.pages.yunjichina.com.cn/user_manual/exports/⽔滴2使⽤说明V0.9.6.html#11-电源总开关
3/48
2. Machine charging
2.1 Placement of charging piles
The charging pile needs to be placed on the wall, and there should be no other objects on the
two sides of the center of the charging pile.
The charging pile needs to be placed on a flat ground, not on a slope or carpet.
The height of the charging piece of the charging pile needs to be kept at the same height as the
charging contacts on the machine. If there is an error, it is necessary to adjust the bottom of the
charging pile and increase or decrease the filling appropriately.
The position of the charging pile needs to be fixed relative to the scene to avoid movement due
to personnel movement or other reasons in the later period. The logo can be pasted on the
ground or fixed by double-sided tape.
When multiple machines are used at the same time in the same scene, the distance between
the charging piles should not be less than 1.5m.
After making sure that the charging pile is properly placed, connect the charging pile to the power
supply through the power cord. At this time, a green indicator light will light up on the charging pile.
2.2 Manual charging
There is a one-meter-long hand charging cable behind the charging pile, and a vertical cover is
attached to the right side of the machine. The cover is fixed by magnetic suction. You can suck
it out with the supplied suction cup. After removing the cover, you can see the hand charging
port. Manually insert the plug at one end of the cable into the hand charging port on the
machine end. After the normal connection, the indicator light of the charging pile will be
changed to red.