User Manual

Manual
waterdocs.pages.yunjichina.com.cn/user_manual/exports/⽔滴2使⽤说明V0.9.6.html#11-电源总开关
24/48
2.1.3.2 Restart the software
After clicking and confirming, the chassis software system will be restarted. When restarting, all
tasks that the machine is executing will be cancelled, and it will take 30-50 seconds to restart.
During this period, the monitoring page will refresh to reconnect to the chassis.
Do not restart the software during the software upgrade process, it may cause the software to
fail to start normally!
2.1.3.3 Power off and restart
After clicking and confirming, power off the whole machine and then power on again, which is the
same as manually pressing the power off button, powering off and then powering on again. During
shutdown, the upper body power supply will also be interrupted. It takes 1~2 minutes to restart the
whole machine.
Do not interrupt the power and restart during the software upgrade process, it may cause the
software to fail to start normally!
2.1.3.4 Shutdown
After clicking and confirming, the machine will be powered off and shut down. If you do not use the
machine for a long time, you need to manually turn the main power switch to the off state. You need
to turn it on manually next time you use it.
Do not shut down the power during the software upgrade process, it may cause the software to
fail to start normally!
2.1.3.5 Update & self-diagnosis
2.1.3.5.1 Software update
In this page, you can check whether there is a new version of the software, and upgrade the
software version to the latest. The chassis will release new versions every once in a while to fix
known problems or add new features. When upgrading the software, you need to ensure that the
machine is connected to the Internet and has sufficient power. The machine will not be upgraded
when it is in the task state. It is necessary to ensure that the machine will not be restarted or shut
down during the upgrade process.