User Manual

Manual
waterdocs.pages.yunjichina.com.cn/user_manual/exports/⽔滴2使⽤说明V0.9.6.html#11-电源总开关
17/48
at an angle of
90°. As shown
below.
The
default
deceleration
width of the
deceleration
point is 50cm
before and after
the point, such
as the position
of the blue
arrow. The
deceleration
distance can be
configured in
the point
properties.
Each point needs to be set with a different name, even if the floor is different, if it is the same,
the previous point will be covered. It is recommended to use floor plus room name or floor plus
other style signs.
2.1.2.2.1 Special point calibration rules
Elevator point:
The points in the elevator need to ensure that the calibration timing of each floor is
consistent with the relative position of the elevator, otherwise the map will shift after the
elevator reaches the target floor.
When there is only one machine and one-step elevator, the elevator waiting point can be
omitted.
Gate point:
When calibrating the gate position, the bottom side and the top angle of the point triangle
should be calibrated horizontally in the middle of the gate or gate. The point and the
channel are at an angle of 90 degrees. As shown