User's Manual
ENEN
17 18
Change User Code
Using user code can wake up keypad, or send Arm, Disarm, Stay
Mode commands to the control panel.
Change User Code
8 new user code
Enter setup state, input:
When one beep is heard and the LED indicator keeps on for
10 seconds, the setup is successful.
Note: User code is 4 digits; default code is “1234”.
Change Admin Code
Using admin code can wake up keypad, send Arm, Disarm, Stay
Mode commands to the control panel, and also change keypad
settings.
For your safety, it is suggested to change both user codes and
admin codes after your purchase.
Change Admin Code
9 new admin code
Enter setup state, input:
When one beep is heard and the LED indicator keeps on for
10 seconds, the setup is successful.
Note: Admin code is 6 digits; default code is “123456”.