User's Manual

07 08
The control panel will hoot on-site with indicator ashing, users
will receive an emergency message from App.
Press the [stay ] button, the indicator on the remote control
blinks once, and then press [Arm
] button within 3 seconds
to mutely arm the system.
Press the [stay ] button, the indicator on the remote control
blinks once, and then press [Disarm
] button within 3
seconds to mutely disarm the system.
Zone modes
There are three zone modes available for the sensors.
Normal zone: In arm or home arm state, the detectors set to
normal zone work normally. Once intrusion is detected, the
detectors trigger an alarm.
Home mode zone: When system is in home arm state, the
detectors set to home mode zone are disarmed. The detectors set
to other zones are armed. That is, partial arm.
24-H zone: The detector set to 24-H zone trigger an alarm
immediately when detecting intrusion, no matter the system is
armed or disarmed.
Sensors in This Kit Zone Mode (Default Setting)
DS2300 Door/Window Contact
Normal Zone
(can be changed through App)
Note: The zone mode of 24-hour zone sensor can not be changed.
Door/Window Contact
The contact contains a transmitter and a magnet, which can be
mounted on a door, window or any objects that can be opened
or closed. When the transmitter and magnet are separated over
2 cm, the contact will send a signal to the control panel to trigger
an alarm.
Overview
Front Side
LED Indicator
Transmitter
Magnet
Back Side
Tamper Switch
LED Indication
Blinks once: Door/window open detected.
Blinks once per 3 seconds after triggered: Low battery. Push
notication will be sent to App. Please change battery as soon as
possible.
Note: When tamper switch is pressed, system will alarm immediately.