User's Manual

RC-80
Operation Manual
The remote control enables you to turn the alarm system on
and off before entering the home or after exiting. If there is
an emergency, press SOS button on the remote control to
trigger the panel. RC-80, compact and portable, is designed
to fit on a keychain, in a pocket, or in a purse.
Features
LED Indication
LED flashes once:
Low light-level:
sends the transmitting signal
Low battery, please replace the battery
immediately.
Appearance
Disarm
Panic
Stay
Arm
LED Indicator
Specifications
Power supply
Alarm current
Transmitting distance
Radio frequency
Housing material
Operating temperature
Relative humidity
Dimensions (L x W x H)
DC 3V (CR2025 Coin Battery x 1pc)
≤ 7mA
≤80m (in open area)
ABS plastic
-10°C~55°C
≤80% (non-condensing)
58 x 31 x 9.5mm
Arm
Stay
Panic
Mute Arm
Mute Disarm
Disarm
Press to arm the alarm panel and all of the accessories.
(Away Mode)
Press to disarm the security system.
Press to arm all sensors except the ones in zone A,
sensors in zone A will not activate an alarm. (Home Mode)
Press to activate a panic alarm and the control panel auto-dials
the pre-set phone numbers immediately.
Press to arm the system in mute.
Press to disarm the system in mute.
Usage
Ver: RC-80/EN-1108-1.0
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
FCC Statement
315.8599MHz