User's Manual

Pet Immune Function
This sensor adopts dual detection window design to improve detection
accuracy. It was only when both two detection windows detect body
movement will it trigger an alarm. While only one window will not cause
an alarm. Based on this principle, pets less than 25 kgs will not be
detected by the sensor.
PIR-910
Pet-Immune PIR
Motion Detector
User Manual
Introduction
The motion detector is with high performance. It consists of digital dual-
core fuzzy logic infrared control chip and intelligent analysis which
effectively identify interference signal from body movement signals from
body movement signals and reduce false alarm rate. With automatic
temperature compensation and anti-turbulence technology, it easily
adapts to environment changes. The detector also has the advantage of
energy saving, reliability and easy installation. It is suitable for lobby,
hallway detection with a detective range of 0-8m at front. With low
power feedback function, user will get SMS alert about low battery if the
PIR detector is connected to GSM alarm system.
Product Overview
LED Indication
Display
Meaning
1. Detection window
2. LED indicator
3. Snap joint
4. Test button
5. Bracket
Working Mode
Testing Mode
Press the test button, the detector enters
testing mode and detects once every 10
seconds. After 3minutes, the LED indicator
blinks twice, and the detector switches to power
saving mode.
Power Saving Mode
This motion detector has smart power saving function. If the detector is
triggered twice within 3 minutes, it enters sleeping state immediately to save
power. During this period, any movement detected does not generate an
alarm. After no movement within the next 3 minutes, it goes back to
working state again.
Note: When the detector goes into sleeping state, the precondition of alarm is that no
one moves in 3 minutes in the detection area; otherwise it will remain in the sleeping
state.
If the detector is in sleeping state, it is suggested to leave the room and make sure
nobody moves in the detection area. The detector will go back to working state in 3
minutes.
Test
It is to check whether the PIR Motion Detector can work properly or not.
Remove the insulation strip
Press down the snap joint, open the case, and remove the insulation strip to
activate batteries. After self-testing for 1 minute, it enters working state.
Arm the system
Make sure the alarm system is in armed state.
Trigger an alarm
Press the test button until an alarm is triggered. The detector is proved to
be connected successfully and ready for installation.
Side View
Top View
Detection Range
Blink continuously
Blink once
Blink twice
Blink once every 3 seconds
Self testing
Intrusion detected
Testing mode is finished, the detector
enters power-saving mode
Low battery, please replace the battery
as soon as possible
1
2
Infrared sensor: It detects the infrared rays released by human body
motion, please don’t touch the surface and always keep it clean.
Tamper switch: Once the case is opened in work mode, the tamper
switch is triggered and then generates an alarm signal.
Pairing to Control Panel
Control panel enters paring state
Make the control panel in paring state.
Press the test button
Press the test button on the back of the detector twice, the control panel
beeps once to indicate a successful pairing.
Note: If the control panel beeps twice when the above operation is done, it means
the detector has been paired already.
LED ON / OFF
Infrared sensor
Tamper switch
Zone setting
Infrared sensor