User's Manual

07 08
7KHFRQWUROSDQHOZLOOKRRWRQVLWHZLWKLQGLFDWRUÁDVKLQJXVHUV
will receive an emergency message from App.
Press the [stay ] button, the indicator on the remote control
blinks once, and then press
[Arm ] button within 3 seconds
to mutely arm the system.
Press the [stay ] button, the indicator on the remote
control blinks once, and then press
[Disarm ] button within
3 seconds to mutely disarm the system.
Zone modes
There are three zone modes available for the sensors.
Normal zone: In arm or home arm state, the detectors set to
normal zone work normally. Once intrusion is detected, the
detectors trigger an alarm.
Home mode zone: When system is in home arm state, the
detectors set to home mode zone are disarmed. The detectors set
to other zones are armed. That is, partial arm.
24-H zone: The detector set to 24-H zone trigger an alarm
immediately when detecting intrusion, no matter the system is
armed or disarmed.
Sensors in This Kit Zone Mode (Default Setting)
DS2300 Door/Window Contact
Normal Zone (can be changed through
App)
Note: The zone mode of 24-hour zone sensor can not be changed.
Accessories
Remote Control
Overview
LED Indicator
Guide Point For The Blind
Arm
Disarm
Stay
SOS
Metal Ring
Note: If you press any button, the LED indicator is dusky and lights off after
ÁDVKLQJWZLFHTXLFNO\PHDQVWKHUHPRWHFRQWUROEDWWHU\LVH[KDXVWHG
Button System Status
Press once to arm the system. The siren beeps once and the
UHGLQGLFDWRUZLOOOLJKWRQWRFRQÀUPWKHV\VWHPLVDUPHG
Press once to disarm the system. The siren beeps twice and the
JUHHQLQGLFDWRUZLOOOLJKWRQWRFRQÀUPWKHV\VWHPLVGLVDUPHG
Note: System will alarm immediately if 24-hour zone detector
or tamper switch of sensor is triggered.
Press once to home arm the system, the siren beeps once after
VHFRQGVDQGWKHEOXHLQGLFDWRUZLOOOLJKWRQWRFRQÀUPWKH
system is in home mode.
Note: System stops handling signal from home mode zone
detector, which enable users to move freely at home.
ENEN