User's Manual

Disarm
Rotate the Keypad Ring to the left, and then enter the Keypad
password (if you have not changed the default password, Press the
left top key 6 times). The indicators will turn to Green.
Installation
Place the Keypad near the
entrance of your home that is
convenient for you to control
the system on your way out/in.
Set the K1 system to Test
Mode, and then trigger the
Keypad by pressing the
Tampering Switch on the back
of the Keypad
;6ɑ
;6ɑ
The K1 Hub will sound 3 beeps to confirm the connection and
range with K1 Hub is good.
Start to install the Keypad with by supplied double-sided tape or
screws.
Notice: Removing the Back Cover off of the KP-20 will result in
an alarm; you can disarm the alarm and continue the installation.
Specications
Model: KP-20
Power: 3V CR123A li-Mn battery x 2 pcs
Frequency: 868MHz/EU or 915MHz/Americas (±75KHz)
Wireless range: ≤ 80 m (in open area)
Operating conditions:
0-50°C / 32° - 122°F, humidity < 90% RH (non-condensing)
Dimensions (L x W x H): 80 x 80 x 35.5mm / 3.15" x 3.15" x 1.34"
Frequency: 915MHz (±75KHz)