Owner's Manual

ESP/BAS Malfunction Indicator Light and

ESP/TCS Indicator Light

The Malfunction Indicator Light for the ESP is

combined with the BAS indicator. The ESP/

BAS Malfunction Indicator Light and the ESP/

TCS Indicator Light in the instrument cluster

both come on when the ignition switch is turned to the

ON position. They should go out with the engine run-

ning.

The system will turn the ESP/BAS Malfunction Indicator

Light on continuously while the engine running if it

detects a malfunction in either the ESP or the BAS or

both. If the light remains on after several ignition cycles,

and you have driven the vehicle several miles (kilome-

ters) at speeds greater than 30 mph (48 km/h), and the

ESP is synchronized (refer to Synchronizing ESP), see

your authorized dealer as soon as possible to have the

problem diagnosed and corrected.

NOTE:

•

The ESP/TCS Indicator Light and the ESP/BAS Mal-

function Indicator Light will turn on momentarily

each time the ignition switch is turned ON.

•

Each time the ignition switch is turned ON, the ESP

system will be on even if it was turned off previously.

•

The ESP control system will make buzzing or clicking

sounds when it is active. This is NORMAL; the sounds

will stop when ESP becomes inactive following the

maneuver that caused the ESP activation.

STARTING AND OPERATING 341