Owner`s manual

7. Have the tire inspected and repaired or replaced at the
earliest opportunity at an authorized dealer or tire ser-
vice center.
8. Replace the Sealant Bottle (1) at your nearest autho-
rized Mopar威 parts dealership as soon as possible. Refer
to “(H) Sealant Bottle Replacement.”
(G) Distributing TIREFIT Sealant to Better Enable
Tire Inflation
NOTE: Use this procedure only if directed here from
Step 1 of “(D) After Injecting TIREFIT Sealant.”
1. Press the Air Pump Power Button (3) to
turn OFF the TIREFIT kit. Then, disconnect the
Clear Sealant Hose (7) from the valve stem,
reinstall the Yellow Cap on the fitting at the
end of the hose, and place the TIREFIT kit in the vehicle.
CAUTION!
Failure to reinstall the Yellow Cap on the fitting at
the end of the Clear Sealant Hose (7) can result in
sealant contacting your skin, clothing, and the vehi-
cle’s interior. It can also result in sealant contacting
internal TIREFIT kit components causing permanent
damage to the kit.
2. Drive the vehicle forward approximately 30 to 50 feet
(9 to 15 m) to distribute the sealant more evenly within
the tire.
3. Return to Step 1 of “(D) After Injecting TIREFIT
Sealant” and attempt to inflate the tire. However, this
time, if the tire fails to inflate to 26 psi (1.8 bar) within
15 minutes, the tire is too badly damaged. Do not attempt
to drive the vehicle further. Call for assistance.
316 WHAT TO DO IN EMERGENCIES