Owner`s manual

To Enter the Trunk:

• With a valid Keyless Enter-N-Go™ Key Fob

located outside the vehicle and within 3 ft

(1.0 m) of the deck lid, press the button on

the located on the center of the light bar

which is located on the deck lid above the

license plate.

NOTE:

Refer to your Owner's Manual on the DVD for

further information.

Engine Starting/Stopping

Starting

• With a valid Keyless Enter-N-Go™ Key Fob inside the vehicle.

• Place the shift lever in PARK or NEUTRAL.

• While pressing the brake pedal, press the ENGINE START/STOP button once. If the engine

fails to start, the starter will disengage automatically after 10 seconds.

• To stop the cranking of the engine prior to

the engine starting, press the button again.

NOTE:

In case the ignition switch does not change with

the push of a button, the RKE transmitter (Key

Fob) may have a low or dead battery. In this

situation a back up method can be used to

operate the ignition switch. Put the nose side

of the Key Fob against the ENGINE START/

STOP button and push to operate the ignition

switch.

Stopping

• Place the shift lever in PARK.

• Press the ENGINE START/STOP button once. The ignition switch will return to the OFF

position.

• If the shift lever is not in PARK, the ENGINE START/STOP button must be held for two

seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut off.

GETTING STARTED