Owner`s manual

To Lock the Vehicle:

• Both front door handles have LOCK buttons

located on the outside of the handle. With

one of the vehicle's Keyless Enter-N-Go™

Key Fobs located outside the vehicle and

within 5 ft (1.5m) of the driver's or passenger

front door handle, press the door handle

LOCK button to lock all four doors and

trunk.

NOTE:

• If “Unlock All Doors 1st Press” is programmed all doors will unlock when you grab hold of the

front driver's door handle. To select between “Unlock Driver Door 1st Press” and “Unlock All

Doors 1st Press”, refer to the Uconnect Touch™ Settings in your vehicle's Owner's Manual on

the DVD or Programmable Features in this guide for further information.

• If “Unlock All Doors 1st Press” is programmed all doors and trunk will unlock when you press the

trunk button. If “Unlock Driver Door 1st Press” is programmed only the trunk will unlock when

you press the trunk button. To select between “Unlock Driver Door 1st Press” and “Unlock All

Doors 1st Press”, refer to the Uconnect Touch™ Settings in your vehicle's Owner's Manual on

the DVD or Programmable Features in this guide for further information.

• If a Key Fob is detected in the vehicle when locking the vehicle using the power door lock

switch, the doors and trunk will unlock and the horn will chirp three times. On the third attempt,

your Key Fob can be locked inside the vehicle.

• After pressing the Keyless Enter-N-Go™ LOCK button, you must wait 2 seconds before you

can lock or unlock the vehicle using the door handle. This is done to allow you to check if the

vehicle is locked by pulling the door handle, without the vehicle reacting and unlocking.

•

If a Keyless Enter-N-Go™ door handle has not been used for 72 hours, the Keyless Enter-N-Go™

feature for that handle may time out. Pulling the deactivated front door handle will reactivate the

door handle's Keyless Enter-N-Go™ feature.

GETTING STARTED