User guide

• Press the FUNCTION SELECT button

to accept a selection. The FUNCTION

SELECT button also resets trip functions.

UNIVERSAL GARAGE DOOR OPENER

Programming HomeLink

Begin Programming

• The HomeLink

buttons are located in the

overhead console.

• Erase all channels before you begin

training by holding the two outside buttons

for up to 20 seconds until “CHANNELS

CLEARED” appears in the EVIC display.

• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN

position.

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink

buttons

while keeping the EVIC display in view. Simultaneously, press and hold both the

chosen HomeLink

button and the hand-held transmitter button until the EVIC

display changes from “CHANNEL # TRAINING” to “CHANNEL # TRAINED.” This

may take up to 30 seconds, or longer in rare cases.

• Press and hold the just-trained HomeLink

button; if the channel has been trained,

the EVIC display will show “CHANNEL # TRANSMIT” and the device should operate.

WARNING!

• Your motorized door or gate will open and close while you are training the

universal transceiver. Do not train the transceiver if people or pets are in the

path of the door or gate. Only use this transceiver with a garage door opener

that has a “stop and reverse” feature as required by Federal safety standards.

This includes most garage door opener models manufactured after 1982. Do not

use a garage door opener without these safety features. Call toll-free

1–800–355–3515 or, on the Internet, at www.HomeLink.com for safety

information or assistance.

• Vehicle exhaust contains Carbon Monoxide (CO), a dangerous gas. Do not run

your vehicle in the garage while training the transceiver. Exhaust gas can cause

serious injury or death.

NOTE: If you are having difficulty training your HomeLink

and your garage door

was manufactured after 1995, you may have a rolling code system. Follow the steps

below for programming a rolling code system.

ELECTRONICS