User Guide

THEFT ALARM

To Arm

• Keyless Enter-N-Go™ button installed: Press the Keyless Enter-N-Go™ Start/Stop button

until the Electronic Vehicle Information Center (EVIC) indicates that the vehicle ignition is

“OFF ”. Press the power door lock switch while the door is open, press the Key Fob LOCK

button, or with one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the

driver's and passenger front door handles, press the Keyless Enter-N-Go™ LOCK button

located on the door handle.

• Keyless Enter-N-Go™ button not installed: Turn the ignition switch to the “OFF” position.

Press the power door lock switch while the door is open, press the Key Fob LOCK button, or

with one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and

passenger front door handles, press the Keyless Enter-N-Go™ LOCK button located on the

door handle.

NOTE:

After pressing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds before you

can lock or unlock the vehicle via the door handle.

To Disarm

• Keyless Enter-N-Go™ button installed: Press the Key Fob UNLOCK button or with one of

the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and passenger

front door handles, grab the Keyless Enter-N-Go™ door handle and enter the vehicle, then

press the Keyless Enter-N-Go™ Start/Stop button (requires at least one valid Key Fob in the

vehicle).

• Keyless Enter-N-Go™ button not installed: Press the Key Fob UNLOCK button or with one

of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and passenger

front door handles, grab the Keyless Enter-N-Go™ door handle and enter the vehicle, then

turn the ignition to the ON/RUN position.

GETTING STARTED