User Guide

Flashing Lights With Lock

• The turn signal lights flashing, when the doors are locked or unlocked, feature can be turned

on or off. To turn this feature on or off:

•

Press and hold the UNLOCK button for at least four seconds, but no longer than 10 seconds.

Then, press and hold the LOCK button while still holding the UNLOCK button.

• Release both buttons at the same time.

UNIVERSAL GARAGE DOOR OPENER

(HomeLink®)

• HomeLink® replaces up to three hand-held transmitters that operate devices such as garage

door openers, motorized gates, lighting or home security systems. The HomeLink® unit is

• The HomeLink® buttons that are located in the overhead console or sunvisor designate the

three different HomeLink® channels.

• The HomeLink® indicator is located above the center button.

Before You Begin Programming

HomeLink®

• Ensure that your vehicle is parked outside of

the garage before you begin programming.

• For efficient programming and accurate

transmission of the radio-frequency signal,

it is recommended that a new battery be

placed in the hand-held transmitter of the

device that is being programmed to the

HomeLink® system.

• Erase all channels before you begin pro-

gramming. To erase the channels, place the ignition switch into the ON/RUN position, then

press and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds or until the

red indicator flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time.

Do not erase channels when programming additional buttons.

• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on the

Internet at www.HomeLink.com for information or assistance.

ELECTRONICS