Installation manual

Page | 9 PVT-MCT10A-EN
2.3 Optional/Recommended Components
2.3.1 Mount Legs (set of 2 per MCT) (Optional)
Our Mount Legs enable installation of the MCT at the recommended angle from a flat base. A
flat base built from Unistrut (or similar structure) is required. The mounting portion of this
manual was written for use with our Mount Legs. If you choose to not use our Mount Legs
please consult an engineer for an alternative method. These can be seen below in Figure 5 and
Figure 6.
2.3.2 Stand Clamps (per MCT) (Optional)
Our Stand Clamps are used to secure the Mount Legs down to the Unistrut section. The
mounting portion of this manual was written for the use with our Stand Clamps. If you choose
to not use our Stand Clamps please consult an engineer for an alternative method. These can
be seen below in Figure 5 and Figure 6.
2.3.3 Header Pipes (per MCT) (Optional)
Our steel Header Pipes are the recommended product to use to connect the plumbing between
MCT’s (Carbon and Stainless Steel available). The Header Pipe portion of this installation
manual was written for use with our Header Pipes. If you choose to not use our Header Pipes
please consult an engineer for an alternative method. These can be seen below in Figure 6.