User manual

2110 Temperature Controller
Chromalox 2110
1
Section 1—Quick Setup
Section 1–Quick Setup
After the controller is properly wired into the system, the user
only needs to verify the sensor input and control type and adjust
the set point.
Setting the Sensor and Control Mode
Adjust the dip switches located on the bottom of the unit as
shown in Figure 1.1. The factory settings are J, TC, °F, and PI. It
is simpler to adjust the dip switch prior to mounting the 2110.
Adjusting the Set Point
1. Apply power to the unit.
2. To adjust the set point on the Chromalox 2110 Temperature Con-
troller, press and hold the Set Point button (see Figure 1.2). The
Set Point light is illuminated.
3. While still pressing the Set Point button, press either the or
button to adjust the set point to the desired value (see Figure 1.3).
Holding the or button increases the speed of the set point
changes.
The Controller is now operational with factory settings. For more
precise control, set up of the alarm, etc., see Section 4 – Adjust-
ing Set Point and Configuration.
Figure 1.1
Dip Switch Settings
J
RTD
˚C
ONOF
K
TC
˚F
PI
J
RTD
˚C
ONOF
K
TC
˚F
PI
Figure 1.2
Establishing the Set Point
Figure 1.3
Adjusting the Set Point
Load
Alarm
°F
°C
Temp
Point
Set Point
Chromalox 2110
Load
Alarm
°F
°C
Temp
Point
Set Point
Chromalox 2110