User manual

2110 Temperature Controller
Chromalox 2110
13
Section 4–Adjusting Set Point and Configuration
4. Press the or buttons to adjust the value (only the value is
displayed during adjustment). See Figure 4.7. The new value
is set when the or button is released.
5. Press and hold the Set Point ( ) button and press the
button to advance to the next menu. See Figure 4.8. (Holding
the Set Pointt ( ) button and pressing the button moves
through menus in the opposite direction.)
Repeat steps 4 and 5 through the configuration menus.
Configuration
continued
Exit Configuration
To exit configuration mode, press and hold both the and but-
tons for three seconds to return to the operation mode.
Note: If no buttons are pressed for three minutes while in user
configuration mode, then the controller will exit user configura-
tion and return to the operation mode.
Load
Alarm
˚ F
˚
C
Temp
Set
Point
Set Point
Chromalox 2110
Load
Alarm
˚F
˚C
Temp
Set
Point
Set Point
Chromalox 2110
Load
Alarm
°F
°C
Temp
Point
Set Point
Chromalox 2110
Figure 4.3
Figure 4.5
Figure 4.6
Figure 4.4
Figure 4.7
Load
Alarm
˚ F
˚ C
Temp
Set
Point
Set Point
Chromalox2110
Figure 4.8
Load
Alarm
˚ F
˚ C
Temp
Set
Point
Set Point
Chromalox 2110
Load
Alarm
˚ F
˚ C
Temp
Set
Point
Set Point
Chromalox 2110
Adjust lock
to 458
Move to
next menu
Continue
until SP is
displayed
Adjust the
set point
value
Continue
through the
configuration
menus