User manual

Chromalox 2110

Section 3–Installation and Wiring

Mount the 2110

1. Cut out a 1/4 DIN, 3.6-inch (92mm) square hole in the mount-

ing panel.

2. Insert the unit into the mounting hole as shown in Figure 3.4.

3. Slide the front mounting collar onto the back of the controller.

4. Slide the rear mounting collar onto the back of the controller

until the holding tabs securely engage with the holding tab

slots in the controller housing (see Figure 3.4).

5. Tighten the four rear collar mounting screws until the unit is

held ﬁrmly in the panel. CAUTION: Do not overtighten.

The controller will now be held ﬁrmly in place.

Mounting

continued

Figure 3.3

Mounting Dimensions

Load

Alarm

°F

°C

Temp

Point

Set Point

Chromalox 2110

(101.6)

(101.6) (102) (92)

(92)

(90)

3.6

(92)

(10)

(12.7)

Figure 3.4

Mounting the 2110

Front Collar

Rear Collar

Mounting Screw

Holding

Tabs

Holding

Tabs

Slots