User`s manual

ManualsBrandsChromalox ManualsHousehold Appliances1603

GBGB

P19P19

P19

Automatic calculation of "relativeAutomatic calculation of "relative

Automatic calculation of "relative

cooling gain"cooling gain"

cooling gain"

This parameter is only present if P5 is 5 and P15

is not 0.

OFFOFF

OFF= the SMART function does

NOT NOT

NOT calculates

the "relative cooling gain".

ONON

ON = the SMART function calculates the "relative

cooling gain".

P20P20

P20

Minimum integral time value calculatedMinimum integral time value calculated

Minimum integral time value calculated

by the SMART functionby the SMART function

by the SMART function

This parameter is only present if P15 is not 0.

It can assume the following values:

model 1603E:

between 0.1 (1 tenth of a second)

and 2.0 (2 minutes)

model 1601E:

between 00.01 (1 second) and

2.00 (2 minutes).

P21P21

P21

Extension of the anti-reset-windExtension of the anti-reset-wind

Extension of the anti-reset-wind

upup

Span: from -30 to +30 % of the proportional band.

NOTENOTE

NOTE: a positive value increases the high limit of

the anti-reset-wind up (over set point) while a

negative value decreases the low limit of the anti-

reset-wind up (under set point).

The advanced configuration procedure is

completed and the instrument shows "

CnFCnF

CnF" on the

display.

To quit the configuration, press SMT and FUNC

simultaneously (press first SMT and immediately

afterwards FUNC) keeping both the pushbuttons

pressed for three seconds.

P22 - Option selection (out 3 or digitalP22 - Option selection (out 3 or digital

P22 - Option selection (out 3 or digital

input)input)

input)

0 = output not used

1 = Alarm 2 output - Process alarm

2 = Alarm 2 output - Band alarm

3 = Alarm 2 output - Deviation alarm

4 = Digital input used for SP/SP2 selection.

5 = Timer mode 1 (see below)

6 = Timer mode 2 (see below)

7 = Timer mode 3 (see below)

8 = Timer mode 4 (see below)

9 = Timer mode 5 (see below)

10 = Timer mode 6 (see below)

11 = Timer mode 7 (see below)

NoteNote

Note:

1) Select P22 value in accordance with the

installed hardware.

2) Setting P22 equal to 1, 2 or 3, if

AL2AL2

AL2

parameter is out of range, it will be aligned to

its low limit.

3) Setting P22 equal to 4, 5 or 8, if

sp2sp2

sp2

parameter is out of range, it will be aligned to

rlrl

rl value.

4) Setting P22 equal to 6 or 7,P5 parameter will

be forced to 0 and if

sp2 sp2

sp2 parameter is out of

range, it will be aligned to

rlrl

rl value.

5) Setting P22 equal to 9 or 10,P5 parameter will

be forced to 0.

6) When P22 parameter pass from a value equal

or greater than 9 to e value lower than 9, at

the next start up the controll output will be

forced to "enabled".

Timer functionsTimer functions

Timer functions

Notes about all timer modes:

1) At power off the time value and status will be reset.

2) The time parameter (

t) can always be modified

but the new value become operative at the next

start time only.

1601-03-1-CX.pmd 13/01/2004, 10.4211