User`s manual

ManualsBrandsChromalox ManualsHousehold Appliances1603

GBGB

P15P15

P15

SMART function enabling/SMART function enabling/

SMART function enabling/

disablingdisabling

disabling

0 = The SMART function is disabled

1 = SMART function enabling/disabling is

NOTNOT

NOT protected by the safety code.

2 = SMART function enabling/disabling is

protected by the safety code.

P16P16

P16

Maximum value of the proportional bandMaximum value of the proportional band

Maximum value of the proportional band

automatically settable by the SMARTautomatically settable by the SMART

automatically settable by the SMART

functionfunction

function

This parameter is available if P15 is not 0. It can

assume the following values:

model 1603E:

between P17 or P18 and 99.9%

model 1601E:

between P17 or P18 and 100.0%

P17P17

P17

Proportional minimum band valueProportional minimum band value

Proportional minimum band value

automatically settable by theautomatically settable by the

automatically settable by the

SMART function ( one control outSMART function ( one control out

SMART function ( one control out

only)only)

only)

This parameter is only displayed if P5 is not 5 or

P15 is not 0.

It may be programmed from 1.0% to the value of

P16.

P18P18

P18

Proportional minimum band valueProportional minimum band value

Proportional minimum band value

automatically settable by theautomatically settable by the

automatically settable by the

SMART function (two control outs,SMART function (two control outs,

SMART function (two control outs,

heating/cooling)heating/cooling)

heating/cooling)

This parameter is only present if P5 is 5 and P15 is

not 0.

This parameter may be programmed from 1.5% to

the value of P16.

To make the device

“Locked” enter a number

different from the “secret

code”.

B) The key is enabled: no

parameter can be modified

apart from

SPSP

SP,

sp2 sp2

sp2 and

t t

t .

To “Unlock” the device,

insert the “secret code”.

500 to 999:500 to 999:

500 to 999: Selecting a secret code between

these two numbers, everything will occur as

explained above except that when the device is

“Locked” the parameters that can be modified are

the set point and the alarm threshold and the time.

NOTE: NOTE:

NOTE: The instrument shows on the display the

value

2 for any value of P11 between 2 and 999.

P12P12

P12

Out maximum rate of riseOut maximum rate of rise

Out maximum rate of rise

This parameter is only available if

PbPb

Pb is not 0.

Programmable from 1 to 25% of the out signal per

second.

Over 25%/s the instrument displays “

InFInF

InF” to

indicate the exclusion of the limitation.

P13 =P13 =

P13 =

Not usedNot used

Not used

P14 =P14 =

P14 =

Protected parameters displayProtected parameters display

Protected parameters display

This parameter is only available if P11 is not 0.

This parameter enables/disables the display of the

protected parameter during "operator mode".

OFFOFF

OFF= the protected parameters are not displayed

ONON

ON = the protected parameters are displayed

ONON

nnnnnn

nnn

1601-03-1-CX.pmd 13/01/2004, 10.4210