User`s manual
6
GBGB
GBGB
GB
4.4.
4.4.
4.
CONFIGURATIONCONFIGURATION
CONFIGURATIONCONFIGURATION
CONFIGURATION
4.14.1
4.14.1
4.1
PUSHBUTTON FUNCTIONPUSHBUTTON FUNCTION
PUSHBUTTON FUNCTIONPUSHBUTTON FUNCTION
PUSHBUTTON FUNCTION
FUNCFUNC
FUNCFUNC
FUNC This saves the new value of the
selected parameter and goes to the
next parameter (increasing order).
SMTSMT
SMTSMT
SMT This scrolls back the parameters
without saving the new value.
This increases the value of the
selected parameter.
This decreases the value of the
selected parameter.
4.24.2
4.24.2
4.2
POSSIBLE PROTECTION OF THEPOSSIBLE PROTECTION OF THE
POSSIBLE PROTECTION OF THEPOSSIBLE PROTECTION OF THE
POSSIBLE PROTECTION OF THE
PARAMETERSPARAMETERS
PARAMETERSPARAMETERS
PARAMETERS
Access to the configuration, and the display and
modification of the operative parameters, can be
protected by a secret code. The code is entered in
configuration, by means of parameters P11 and
P14.
P11 = 0P11 = 0
P11 = 0P11 = 0
P11 = 0 All the operator parameters can be
displayed and modified. Access to the
configuration is free.
P11 = 1 and P14 = OnP11 = 1 and P14 = On
P11 = 1 and P14 = OnP11 = 1 and P14 = On
P11 = 1 and P14 = On All the operator parameters
can be displayed but not modified, apart from SP
(Set Point), SP2 and T. Access to the
configuration is only possible by entering code 408
when requested.
P11 = 1 and P14 = OFFP11 = 1 and P14 = OFF
P11 = 1 and P14 = OFFP11 = 1 and P14 = OFF
P11 = 1 and P14 = OFF No operator parameter
can be displayed and modified, apart from SP, SP2
and T. Access to the configuration is only possible
by entering code 408 when requested.
P11 = 2/499P11 = 2/499
P11 = 2/499P11 = 2/499
P11 = 2/499 In this case the value programmed in
P11 represents a numerical key which can be
used to protect access to the configuration and,
in operator mode, the modification of the
parameters (SP can always be modified).
To set P11 see section 4.4.
3.3.
3.3.
3.
GENERAL OPERATIONGENERAL OPERATION
GENERAL OPERATIONGENERAL OPERATION
GENERAL OPERATION
There are two setup modes for these models:
- Configuration mode
- Operator mode
In general, the configuration mode is the initial
setup of the controller when first installed. Input
type and alarm setup are examples of
Configuration Mode settings. The Operator mode
includes settings that might be adjusted
frequently with daily control operations such as
setpoints, and PID parameters.
1601-03-1-CX.pmd 13/01/2004, 10.426