User manual

Color Block PSU-30 User Manual 8 V2.0 September 2012
www.chroma
-
q.com
When DMX is Lost
If DMX is not detected various output options can be selected: Press Enter, scroll wheel to selection, press
Enter for 2 seconds to save settings.
Off - will snap to off
Hold - will hold the last valid DMX state
Trig - will default to Time Trigger operation
Look 1-31 will snap to the Look of your choice
Look Store
The PSU-30 has 31 internal preset FX Looks for standalone operation, 1-23 are pre-programmed. To replay a
Look in standalone operation, scroll to Look Store, press Enter, scroll and select the desired Look and press
Enter for 2 seconds to save settings. To replay a Look with a DMX console, scroll to Control Mode 16 and
press Enter for 2 seconds. Use the DMX console with the assigned channel to playback the various looks
stored. (1-31 looks in 1 single channel)
Note: DMX has priority over internal Looks.
Looks can be recorded to the internal flash memory by users and will be preserved on power down. However,
looks will be returned to default setting if menu 8 Reset is performed. There are two ways to record a look:
Simple, with DMX console.
Set the PSU-30 to the desired Control Mode. Use a DMX console to adjust channel levels and create the
desired look or effect. Scroll to Look Store and press Enter, scroll to desired Look number and press Enter.
Press Enter again for 2 seconds to save Look.
Advanced, standalone. (DMX is unplugged)
Scroll to Look Store and press Enter, scroll to desired Look and press Enter to access the memory data. The
data is presented as two numbers separated by a letter “c”. The number to the left of the c is the channel
number and to the right is the channel level. Scrolling to the far end of the wheel will show the Mode at which
the selected Look was programmed.
To edit the Mode of a selected Look:
Scroll to Look Store and press Enter, scroll to desired Look and press Enter to access the memory data. Scroll
the wheel to the far end until Mode number is shown and press Enter. Scroll wheel to adjust the Mode
number. Press Enter to toggle back to the channel numbers.
To edit the channel numbers and levels of a selected Look:
Scroll to Look Store and press Enter, scroll to desired Look and press Enter to access the memory data. Scroll
the wheel to select the channel number. To edit the channel level, press Enter and use the scroll wheel to
adjust the level (shown as 0-255). Press Enter to toggle back to the channel number. When the desired effect
is created press Enter for 2 seconds to save Look.
Time Triggers
The PSU-30 has real time triggering of the internal Looks. Press Enter and scroll to desired Time Trigger and
press Enter. Press Enter to toggle between Day, Hour (24), Minutes and Look to be triggered, adjusting the
setting with the scroll wheel as desired. Press Enter for 2 seconds to save settings. By default Time Triggers
will occur on all 7 days unless specified. The triggers will only be activated when the feature “When DMX is
Lost” is set to Trig.
Set Day and Time