User manual

Universal User Manual 6 V1.4 September 2012
www.chroma
-
q.com
Control Function
Red Button Mode access and record
Black Button Decreases (-) the mode level or value
Brown Button Increases (+) the mode level or value
3 digit display Displays mode, monitor or blank display
Push button operation:
The red button is used to scroll through the different modes of operation. The brown or black buttons are used to select the
level or value in that mode. If any mode or value is changed, the display will flash until the red button is pushed to save the
change.
Display operation:
Power-up display
On power-up, the unit will go through its self-calibration mode & the display will show the units software
version.
After the self-calibration finishes, the display will show the DMX address.
Monitor display
If left undisturbed for 5-7 seconds, the display will revert to 'Monitor Mode'.
The first vertical bar indicates that there is power (24VDC) at the unit.
The second vertical bar indicates that there is data (DMX) at the unit.
The horizontal bars indicate the data (DMX) signal level at the unit.
(See also: 'Troubleshooting' section of this manual)
Display flip
The display can be flipped through 180º by pressing & holding the red button, then pressing the black button.
Display blank
The display can be set to auto-blackout after short time. This is selected through the Display mode menu (see later in this
section).
Reset
If the red button is held down & the brown button pressed, the unit will reset to the factory default
settings. This feature is particularly useful when the units are used in many different configurations or
shows. The reset function is also available via DMX (see remote operation section of this manual).