User manual

Universal User Manual 11 V1.4 September 2012
www.chroma
-
q.com
3) Manually turn the fixed gear of the shaft to slowly roll the gel string onto the TUR. Continue rolling the gel onto the
TUR until the other end is reached.
4) Firmly holding the gear of the rear fixed shaft (to stop it moving), gently pull the gel tab towards you. This ensures
that the gel is tightly rolled onto the TUR.
5) Rotate whole the unit so that the motor/fan/ electronics section on your left hand side. Place the gel beside TUR.
6) Use 25mm /1" pieces of tape to secure the gel to the TUR top & bottom, & on both sides (a black line has been
scribed along the TUR to assist).
7) Manually roll some of the gel string onto the TUR to check it is seating itself correctly.
Completion & testing
1) Plug in the unit, & check that it goes through the initialisation sequence correctly. Check that the gel runs smoothly
& does not bind up on the TUR's.
2) Unplug the unit, replace the front cover & secure with the M3 screws.
3) Run a test sequence to allow the gel string to 'bed' in. The unit does not have to be attached to a lighting fixture to
perform this. It is recommended that run this sequence for a few minutes (or 3/4 times, end-to-end).
Replacing the gel string (EZ-Load)
Note: See the drawing section of this manual.
1) Follow steps 1+2 in the preparation section.
2) While pressing down the red push button, apply power to the unit.
The display will show the legend PAL
3) Using 25mm/1" long pieces of tape attach the leading edge of the gel string to the plastic TUR at the top & bottom
of the string, ensuring that the gel is centred on the TUR. Move the gel string to the side & attach the other side
string to the TUR with tape (a black line has been scribed along the TUR to assist with this).
4) Press the black push button to advance the gel string onto the TUR.
5) Continue this process until you see the other end of the gel string approaching.
6) Firmly holding the gear of the rear fixed shaft (to stop it moving), gently pull the gel tab towards you. This ensures
that the gel is tightly rolled onto the TUR.
7) Use 25mm/1" pieces of tape to secure the gel to the TUR top & bottom, & on both sides (a black line has been
scribed along the TUR to assist with this).
8) Press the brown push button to move the gel string back onto the TUR. Use the push buttons to move the gel to &
fro, checking that the gel is sitting correctly on the TUR's.
9) Allow the unit to self-calibrate by pressing the brown & black buttons simultaneously or by cycling power to the
unit.