User manual

Universal User Manual 9 V1.4 September 2012
www.chroma
-
q.com
Summary of control functions
Operation or
mode
Operation description Actions required Display
Power-Up Software version - shown on
the unit at power-up.
This shows the software version while the unit is self-
calibrating, before displaying the ‘Monitor Mode’.
rESet This will reset the unit to the
default settings.
While holding down the red button, press the brown
button.
Power Assisted
Loading
(EZ Load)
Used to load a gel string into
the unit.
Hold down the red button during power-up. Pressing
the black button will advance the gel in that direction.
Pressing the brown button will advance the gel in the
opposite direction. Press both brown & black buttons,
or cycle the power, to recalibrate.
Modes (use the red button to scroll through these modes)
DMX addressing
mode
Used to set the units DMX
addresses
The display shows DMX address (1-512). Press
brown or black once to increment/decrement the
value, hold down the brown or black for fast
advance/retreat.
Press red to save the new settings
Fan speed mode Used to set the fan speed of
the unit
The display shows the current gel cooling fan speed.
There are four fan speeds, 1 is the slowest, 4 is the
fastest.
Press brown or black once to increment/decrement
the value
Press red to save the new settings
‘GeL Saver’
mode
Switches on/off the gel saving
mode
The display shows the current gel saver mode. Press
brown or black once to switch between on (1) & off
(0).
Press red to save the new settings
‘SPeed’ mode Used to set the scrolling speed
of the unit
The display shows the current gel scrolling speed.
There are two scrolling speeds, 1 is the slowest & 2
is the fastest.
Press black or brown once to increment/decrement
the value.
Press red to save the new settings
‘disP
PP
Play’ mode Switches on/off the display Switches the display on or off. Display will re-activate
when any button is pressed. Press brown or black to
switch between on (1) & off (0).