User manual

Color Block 2 Plus User Manual 8 V2.2 October 2013
www.chroma
-
q.com
2.3 Fixings
The Color Block 2 Plus fixture also features an integral connection system to enable up to five units to be locked together as a
batten (see below).
The Color Block 2 Plus fixture is supplied with an integral M10 clinch nuts at each end. These can be used to attach the Color
Block 2 Plus fixture to a standard hook clamp or the wide range of Color Block accessories listed below.
Note:
Note:Note:
Note:
Damage may occur if the bolt is too long (M10x16 maximum). In addition, both sides of the fixture feature a fixing slot designed
to accept an M6 bold head.
It is important to ensure that each fixture is also secured with a safety bond. The end plate of each fixture has a fixing hold to
facilitate secondary fixings.
a.
a.a.
a. Integrated connection system
Integrated connection systemIntegrated connection system
Integrated connection system
One end of the Color Block 2 Plus fixture features two protruding locating pins and a catch plate, the other end has two keyhole
slots and a butterfly latch.
1. To connect two fixtures together, firstly mate the two protruding pins from one fixture into the keyhole slots of the other.
2. Then slide the fixtures together so that they are aligned correctly, taking care to get past the extended catch plate.
Note:
Note:Note:
Note: This will be stiff on new fixtures and a twisting action may ease assembly.
3. Finally use the butterfly latch to secure the fixtures together tightly (max 5 units together).
Note:
Note:Note:
Note: It is important to ensure adequate ventilation at the rear of all colour block fixtures. Never place the fixtures directly on
the floor pointing upwards when configured as a batten.