User manual

Color Block 2 Plus User Manual 16 V2.2 October 2013
www.chroma
-
q.com
3. Scroll the wheel and select the frequency
4. Press Enter for 2 seconds to save.
Sync Mode
Sync ModeSync Mode
Sync Mode
In normal operation internally generated FX should stay synchronised between the PSU05B’s/PSU30’s for approx
30 minutes. If better synchronisation is required a timing signal can be run via a RJ45 patch (not crossover) cable
between PSU’s. In order for this to work correctly one PSU05B or PSU30 must be designated as the Master and all
the others must be set to Slave.
To activate sync mode,
1. Scroll the wheel and select “Sync Mode”
2. Press Enter
3. Scroll the wheel and select “Master” or “Slave”
4. Press Enter for 2 seconds to save.