User manual

Color Block 2 Plus User Manual 11 V2.2 October 2013
www.chroma
-
q.com
2.4 Power Supply Mounting
Unique Magic Box interlocking enclosure of the PSU-05B facilitates easy rack mounting when used in pairs and easy truss
mounting via captive nut insert. Rack mounting brackets are available in single unit and dual unit versions, enabling you to
customise your equipment rack or installation by mixing and matching different Magic Box interface units. Ensure adequate
ventilation around the holes in the enclosure. Failure to allow adequate ventilation may result in premature failure of the unit.
The Color Block PSU-30 must be installed in a 2U rack mounted enclosure and be supported front and rear. Ensure adequate
ventilation around the front and rear of the enclosure. Failure to allow adequate ventilation may result in premature failure of the
unit.
2.5 Emulation Mode
The Color Block 2 Plus is fitted with an internal switch that adjusts the lumen output of the unit to simulate the original LED
engine of the Color Block 2 fixtures.
1. Remove the end plate with the rivets.
2. The toggle switch on the edge of the PCB is
on the horizontal position for normal Color
Block 2 Plus operation.
3. Press down the toggle switch to simulate
the lumens output of the Color Block 2.
4. Replace the end plate.