User manual

Color Force User Manual 9 V1.7 November 2013
www.chroma
-
q.com
The number to the left of the “c” is the channel number and to the right is the channel level. Pressing
Up/Down up to the far end will show the Mode at which the selected Look was programmed.
To edit the Mode of a selected Look:
To edit the Mode of a selected Look:To edit the Mode of a selected Look:
To edit the Mode of a selected Look:
1. In “Look Store”, select a Look,
2. Press Enter to access the memory data.
3. Press the Up/Down buttons up to the far end until Mode number is shown then press Enter.
4. Press the Up/Down buttons to adjust the Mode number.
5. Press Enter to toggle back to the channel numbers.
To edit the channel numbers and levels of a selected Look:
To edit the channel numbers and levels of a selected Look:To edit the channel numbers and levels of a selected Look:
To edit the channel numbers and levels of a selected Look:
1. In “Look Store”, select a Look.
2. Press Enter to access the memory data.
3. Press Up/Down buttons and select the channel number.
4. To edit the channel level, press Enter and use the Up/Down buttons to adjust the level (shown as 0-255).
5. Press Enter to toggle back to the channel number.
6. Press Enter for 2 seconds to save the edited Look.
Technical
TechnicalTechnical
Technical
In this mode,
• Frequency settings of the unit can be changed.
• Addressing software for LED engines can be uploaded.
• ETC compatible mode can be set to On or Off
Frequency:
Frequency:Frequency:
Frequency:
The Color Force has four frequency settings available - 600, 1200, 2400 and 4800. This allows for the LED scan
rate to be synchronised with the video camera and avoid a flickering effect.
To change the frequency settings,
1. In “Technical”, select the Frequency.
2. Select the frequency option.
3. Press Enter for 2 seconds to save.
Upload Engines:
Upload Engines:Upload Engines:
Upload Engines:
Addressing software for LED engines can be uploaded to the Color Force from the Chroma-Q Uploader.
1. In “Technical”, select “Upload Engines” then press Enter, and the display shows “Ready”.
2. Connect an XLR 5-pin cable from the Uploader to the unit.
3. Power-up the Uploader - display shows the file name, and “Ready”.
4. Press the “GO” button once to execute the uploading - red indicator light on the “GO” button will blink.
5. An animated arrow is displayed on the Uploader indicating the upload process.
6. All the green LEDs of the unit will light up (low intensity) to indicate completion of a successful Upload
and the Uploader display shows “DONE”.
7. Power-cycle the unit.
(See Quick Start Guide of the Chroma-Q Uploader)
ETC compatible:
ETC compatible:ETC compatible:
ETC compatible:
Colour output of the Color Force fixture can be set to match the Color Picker feature in the ETC Eos consoles.
1. In “Technical”, select “ETC compatible”.
2. Select On or Off.
3. Press Enter for 2 seconds to save.