User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Web Interface
Christie Vive Audio SKA-3D User Manual 79
020-101056-02 Rev. 1 (10-2013)
Trigger Inputs Tab
E Set Master
Volume Level
Specifies the type of volume used by the preset. Available options include: No
Change, and Custom.
F Custom Vol. Level Sets a custom volume level for the specified preset. Move the slider between 0.0 and
10.0 until the desired volume is obtained.
This setting is only available when Set Master Volume Level is set to Custom. If
the Set Master Volume Level is set to No Change, the sliders cannot be moved.
G Save and Load
Settings
Saves the current preset settings, or loads a previously saved preset file.
Click Save to save the current settings. Click Browse to navigate to a previously
saved settings file. Click Load to load a previously saved settings file.
Ref. Item Description
A Trigger Input Sets the default state of the trigger input. Available options include: Normally Low,
and Normally High.
B Switch to Preset Sets the preset to be executed for the specified trigger input. The name of the
selected preset is displayed in the Preset Name column. Available options include:
None, and 1-10.
C Preset Name Provides a test button for each of the named presets. Click Test to test the desired
preset.
D Save and Load
Settings
Saves the current trigger input settings, or loads a previously saved trigger input file.
Click Browse to select a previously saved trigger input setting.
Ref. Item Description