User manual

Web Interface
Christie Vive Audio SKA-3D User Manual 77
020-101056-02 Rev. 1 (10-2013)
Channel Mapping Tab
A
(cont.)
LFE Parametric
EQ (cont.)
• HPF (adjustment) - move the slider to adjust the high-pass filter frequency
between 5 and 40 Hz in 1 Hz increments. The HPF (High-Pass Filter) must be
enabled to use this control.
• LPF (adjustment) - move the slider to adjust the low-pass frequency between
100 and 250 Hz in 1 Hz increments. Select LPF (Low-Pass Filter) to activate
this adjustment.
• Band 1- 4 Center Frequency - move the sliders to adjust the center frequency
between 10 and 250 Hz.
B LFE Level Sets the low-frequency envelope level. Move the slider between 0 and -20 dB.
C Phase Sets the audio phase. Move the slider to adjust the phase between 180° and -180°.
D Test Signal Sends a -20 dBFS pink noise test signal to the subwoofer (LFE).
E Save and Load
Settings
Saves the current equalizer settings, or loads a previously saved LFE EQ file as a
preset. Click Save to save all settings under the LFE EQ tab. The file can then be
loaded as a preset, to quickly configure the SKA-3D. Click Load to load a specified
LFE EQ file that was previously saved. Click Browse to select an EQ settings file.
Ref. Item Description
A Channel Mapping
Sources and
Output Levels
Sets channel mapping sources and allows individual channel output adjustments.
Select the channel source for Aux 1, Aux 2, HI, and VI/N from each of the lists.
Available options include: CH 1 to CH 16, Downmix LCR, Downmix L, and
Downmix R.
Select the output level type for Aux 1, Aux 2, HI, and VI/N from each of the lists.
Available options include: Fixed and Track w/Master Vol.
Ref. Item Description